Bestel eenvoudig via: 
010-2109798
Offertes en vragen via e-mail
info@industry-lubricants.com
Bestel eenvoudig via 010-2109798

FUCHS GLEITMO 625

Een bestelling plaatsen of hulp nodig?

Wij staan klaar om u te adviseren. Bel of mail ons en wij komen zo snel mogelijk bij u terug.
010-2109798
info@industry-lubricants.com
In bulk kopen?
010-2109798
info@industry-lubricants.com
Offerte aanvragen
Bestel nu, snel bezorgd!
Scherpste prijzen, met de laagste prijsgarantie
Veilig online betalen

Artikelomschrijving

Performance Features;temperature range for the dry solid lubricant: -40 / +110 °C;to achieve low friction coefficients/grooving torques for bolted connections, with a low variation;to avoid seizures of stainless steel bolt connections;provides a clear, touch-proof and abrasion-resistant lubricating film;suitable for mass parts;saves assembly time and is particularly suited for automatic systems;is clean and non-greasing;very good adhesion on a lot of material surfaces;contains a UV additive for a UV coating inspection (340 – 380 nm);Description;GLEITMO 625 is a suspension of high-molecular polymers in water. GLEITMO 625 is used as a coating agent and develops a well adhering, touch-proof lubricating film after drying. GLEITMO 625 has been developed to achieve defined low friction coefficients with a minimum variation range.;Field of application;GLEITMO 625 is used for mass part lubrication. A typical application example is the coating of stainless-steel screws/bolts and nuts, self-tapping or self-forming screws, rivets, sheet-metal screws, and chip-board screws.;Method of application;Depending on the requirements, GLEITMO 625 can be diluted with water (at least drinking water quality). As a rule, GLEITMO 625 is used at a dilution ratios of 1: 3 (for centrifuge coating procedures, stringent require-ments) up to 1: 7 (for dipping). In individual cases a dilution ratio of 1: 1 to 1: 2 is used to achieve lowest grooving torques. The parts to be coated must be free of grease. Drums and centrifuges commonly used in the galvanising industry have proved to be convenient in case of large coating quantities. After the coating process it is recommended to dry the parts by hot air (up to a part temperature of approxi-mately 80 °C).;Note;Protect against freezing! In closed original containers at room temperature storable up to 24 months.

Service en specialistisch advies

Wij staan klaar om u te adviseren. Bel of mail ons en wij komen zo snel mogelijk bij u terug.
Neem contact op
010-2109798
bereikbaar op werkdagen van 09:00 - 17 uur
info@industry-lubricants.com
Mail ons direct
© 2020 Industry Lubricants. All Rights Reserved - Duidelijk Online website bouwer 
envelopephone